Attic Exposed Collar Ties

Desperately enough in fact to consider making the major step of pulling down ceiling drywall to expose joists above.

Attic exposed collar ties.

Building codes such as the icc s 2012 international building code section 2308 10 roof and ceiling framing typically specify that where rafter ties are used they are required at intervals ranging from 12 to 24 o c. A collar tie is a tension tie in the upper third of opposing gable rafters that is intended to resist rafter separation from the ridge beam during periods of unbalanced loads such as that caused by wind uplift or unbalanced roof loads from snow. Collar ties prevent rafter separation and uplift. In a frame like this the remaining collar ties are often doubled up putting one 2x on each side of the rafter.

In this how it works article managing editor debra judge silber explains the role of collar and rafter ties in the framing of a roof. Metal brackets or straps can be an acceptable alternative in lieu of the more common use of the wood framed collar ties. Rafter tie or collar tie spacing intervals connection specifications. This balances the construction and makes it look beefier.

I installed some collar ties so i could insulate the ceiling while leaving an air space at the top of the attic for ventilation. Rafter ties resist the forces caused by gravity loads that would otherwise cause the roof to pancake and push out the sidewalls. Collar ties may take up space in the attic of your home but they are there for a reason. Stately attractive and open.

Collar ties are necessary to prevent separation of the roof at the ridge due to wind uplift. Collar ties as per current irc code are required to be at least 1x4 nominal material but are most commonly 2x4 s. Do not mess with the collar ties. The ties allow for a drywall ceiling and add strength to the roof structure.

It is not safe in any way shape or form. Since everything is exposed you should install hurricane ties along the plate and the rafter where it meets the top of the wall. The exposed beam ceiling look is one that many owners of conventional flat ceilings desperately want. I temporarily attached a couple of 2x4s to the rafters and made sure they were level to each other and along their lengths.

The collar ties can be wrapped with drywall or a higher grade of lumber can be used and left exposed. This is on a conventional stick frame non truss structure as engineered roof trusses do not require collar ties from a framing material as they are tied together with metal plates gussets. Collar ties are used for stability to stop the roof spreading or collapsing u have to understand there s a lot of weight on a roof with the roof tiles slates etc and also when u consider the. The 2015 international residential code does not require collar ties or collar beams.