Sometimes i ll use large fender washers to hold them to the wall.
Attaching hose bib flange to corrugated siding.
If you want to hang something from your vinyl siding don t even think about drilling through it to attach a hook to the sheathing.
There are at least three alternative ways to do it.
Builders edge 390.
Build in a slight incline away from the hose bib drill a locator hole and bore a 1 1 8 inch hole.
The hole saw will likely be dull by the time you are done drilling.
Free delivery with 45 order.
Typically the hose bib has a mounting flange with two screw holes.
Predrill a pilot hole for the screws with an 1 8 masonry bit.
When the siding was installed 20 years ago it was cut around the hose bibb.
1 press the flange of the hose bib up against the foundation.
This renders the siding vulnerable to moisture and voids the warranty even if you seal the hole.
Add sections of threaded pipe to reach the location of the hose bib.
Clean the inside of the hose bib in the same fashion until shiny.
Install a union and tee fitting and add a nipple and elbow to reach the level of the hose bib.
But if the hole is too big your screws don t have anything to grab.
I m replacing a few hose bibbs on an older house with aluminum siding.
Drive the screws until they butt against the flange and secure the hose bib to the wall.
Now you have a corrugated side that will go against the wall and a flat side for the spigot to come out of that a flange will lay flat on.
Ignite the torch and heat the joint evenly.
White polypropylene mini mounting block for siding model 146100001 10 68 10 68.
Assemble the hose bib and pipe.
Align the screw holes on the hose bib s flange with the screw holes on the wall.
Beige cream 183 black 16 brown tan 81 gray 34 green 19 red 19 white 70 more ways to filter.
Personally i would not use a latex caulking on fiber cement.
Clean the hose bib.
Plumbing hose 12 universal 321 color family.
They re ugly and if they re not brass they ll rust in time.
Apply the paste flux to the inside of the hose bib and outside of the copper pipe.
While holding the hose bib in position drive a concrete screw through each of the flange s screw holes and into the screw holes on the wall.
These are used to attach the bib to the foundation of the home.
Use either long self tapping screws or construction adhesive to attach it to the wall.
Assemble the hose bib to the pipe placing it in the desired finished position.
I would either paint it to match the metal or you could stain it to add some contrast before you attach it to the wall.
Clean the dust off the siding caulk around the perimeter of the hole then slide your hose bib in and use two 2 stainless steel screws to hold it on.
